Automation Studio

What do you like best?

The simulation process helps a lot, there's no need to go all the time on the field to troubleshoot. Just encode the schematic diagram, put the corresponding value of the components and that's it. When you finally found the problem by simulation you can trace out easily the problem in the field.

What do you dislike?

There was a little bit of problem in tagging the components, there's a lot of fill inbox that are not useful.

Recommendations to others considering the product:

add water pump motor so I can put it together on a pump circuit.

What problems are you solving with the product? What benefits have you realized?

I resolved the problem on a Booster pump system which the cut in and cut out of pressure is not executed well in the system. When I encode the schematic diagram and simulate, System still in error. i check the the oinout of the timer relay and I found out there was a wrong wiring in the control panel which I corrected in the simulation. So when i get in the system panel i knew already which part of the panel that cause the problem.